Copyright (c) 1992-2001 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.4-RELEASE #1: Fri Jan 3 13:34:13 CET 2003 root@kayak.infowar.com:/usr/src/sys/compile/KAYAK_06_SMBus_pcm_DivX_lp_DEBUG Timecounter "i8254" frequency 1193182 Hz CPU: Pentium III/Pentium III Xeon/Celeron (547.62-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x673 Stepping = 3 Features=0x383fbff real memory = 536805376 (524224K bytes) avail memory = 518389760 (506240K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 FreeBSD/SMP: Multiprocessor motherboard cpu0 (BSP): apic id: 1, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 0, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc0438000. Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 10 entries at 0xc00fdf20 apm0: on motherboard apm: found APM BIOS v1.2, connected at v1.2 npx0: on motherboard npx0: INT 16 interface pcib0: on motherboard IOAPIC #0 intpin 19 -> irq 2 IOAPIC #0 intpin 16 -> irq 10 IOAPIC #0 intpin 18 -> irq 15 pci0: on pcib0 pcib2: at device 1.0 on pci0 pci1: on pcib2 pci1: at 0.0 irq 15 isab0: at device 7.0 on pci0 isa0: on isab0 atapci0: port 0xfc90-0xfc9f at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 uhci0: port 0xfca0-0xfcbf irq 2 at device 7.2 on pci0 uhci_run: setting run=0 uhci_run: done cmd=0x0 sts=0x20 uhci_run: setting run=1 uhci_run: done cmd=0x81 sts=0x0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered ums0: Microsoft Microsoft Wireless Intellimouse Explorer\M-. 1.0A, rev 1.10/0.0e, addr 2, iclass 3/1 ums0: 5 buttons and Z dir. ums_attach: sc=0xc1752400 ums_attach: X 8/8 ums_attach: Y 16/8 ums_attach: Z 24/8 ums_attach: B1 0/1 ums_attach: B2 1/1 ums_attach: B3 2/1 ums_attach: B4 3/1 ums_attach: B5 4/1 ums_attach: size=6, id=2 intpm0: port 0x2180-0x218f irq 9 at device 7.3 on pci0 intpm0: I/O mapped 2180 intpm0: intr IRQ 9 enabled revision 0 smbus0: on intsmb0 smb0: on smbus0 intpm0: PM I/O mapped 8000 ahc0: port 0xf800-0xf8ff mem 0xfedff000-0xfedfffff irq 10 at device 8.0 on pci0 aic7880: Ultra Wide Channel A, SCSI Id=7, 16/255 SCBs si0: port 0xfc00-0xfc7f mem 0xfede0000-0xfedeffff,0xfedfec00-0xfedfec7f irq 15 at device 17.0 on pci0 si0: card: SXPCI, ports: 8, modules: 1, type: 72 (SXDC) pcm0: port 0xfcc0-0xfcff irq 10 at device 18.0 on pci0 pcib3: at device 19.0 on pci0 pci2: on pcib3 sym0: <875> port 0x7800-0x78ff mem 0xfeafe000-0xfeafefff,0xfeaff800-0xfeaff8ff irq 2 at device 4.0 on pci2 sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. pcn0: port 0x7ce0-0x7cff mem 0xfeaff400-0xfeaff41f irq 10 at device 5.0 on pci2 pcn0: Ethernet address: 00:10:83:35:91:a2 miibus0: on pcn0 lxtphy0: on miibus0 lxtphy0: 100baseFX, 100baseFX-FDX, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pcib1: on motherboard pci3: on pcib1 orm0: