Copyright (c) 1992-2004 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.10-STABLE #7: Tue Sep 28 13:26:23 EST 2004 root@newserv.familysquires.net:/usr/obj/usr/src/sys/NEWSERV Timecounter "i8254" frequency 1193182 Hz CPU: Pentium II/Pentium II Xeon/Celeron (298.73-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x633 Stepping = 3 Features=0x80fbff real memory = 268435456 (262144K bytes) config> di sn0 config> di lnc0 config> di ie0 config> di fe0 config> di ed0 config> di cs0 config> di bt0 config> di aic0 config> di aha0 config> di adv0 config> q avail memory = 255545344 (249556K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 FreeBSD/SMP: Multiprocessor motherboard: 2 CPUs cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc0580000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc058009c. netsmb_dev: loaded Pentium Pro MTRR support enabled md0: Malloc disk npx0: on motherboard npx0: INT 16 interface pcib0: on motherboard IOAPIC #0 intpin 19 -> irq 2 IOAPIC #0 intpin 17 -> irq 10 IOAPIC #0 intpin 18 -> irq 11 pci0: on pcib0 agp0: mem 0xe0000000-0xefffffff at device 0.0 on pci0 pcib1: at device 1.0 on pci0 pci2: on pcib1 isab0: at device 7.0 on pci0 isa0: on isab0 atapci0: at device 7.1 on pci0 atapci0: ATA channel disabled by BIOS uhci0: irq 2 at device 7.2 on pci0 uhci0: Could not map ports device_probe_and_attach: uhci0 attach returned 6 Timecounter "PIIX" frequency 3579545 Hz chip0: port 0xfcb0-0xfcbf at device 7.3 on pci0 pcib2: at device 13.0 on pci0 pci1: on pcib2 fxp0: port 0xcf80-0xcf9f mem 0xfc900000-0xfc9fffff,0xdc2ff000-0xdc2fffff irq 2 at device 2.0 on pci1 fxp0: Ethernet address 00:08:c7:52:6e:1b inphy0: on miibus0 inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pci0: (vendor=0x8086, dev=0x1960) at 13.1 irq 10 pci0: at 15.0 ahc0: port 0xe400-0xe4ff mem 0xfebfc000-0xfebfcfff irq 11 at device 18.0 on pci0 aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs sym0: <875> port 0xe800-0xe8ff mem 0xfebfd000-0xfebfdfff,0xfebfef00-0xfebfefff irq 2 at device 20.0 on pci0 sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. orm0: