Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.9-RELEASE-p2 #0: Fri Mar 12 09:29:13 CET 2004
    root@:/usr/src/sys/compile/BB
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (200.46-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x634  Stepping = 4
  Features=0x80fbff
real memory  = 134152192 (131008K bytes)
avail memory = 126693376 (123724K bytes)
Programming 24 pins in IOAPIC #0
IOAPIC #0 intpin 2 -> irq 0
FreeBSD/SMP: Multiprocessor motherboard: 2 CPUs
 cpu0 (BSP): apic id:  0, version: 0x00040011, at 0xfee00000
 cpu1 (AP):  apic id:  1, version: 0x00040011, at 0xfee00000
 io0 (APIC): apic id:  2, version: 0x00170011, at 0xfec00000
Preloaded elf kernel "kernel" at 0xc039d000.
VESA: v2.0, 4096k memory, flags:0x0, mode table:0xc00c0d16 (c0000d16)
VESA: S3 Incorporated. ViRGE /DX /GX
netsmb_dev: loaded
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 7 entries at 0xc00fdcf0
apm0:  on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
npx0:  on motherboard
npx0: INT 16 interface
pcib0:  on motherboard
IOAPIC #0 intpin 19 -> irq 2
IOAPIC #0 intpin 16 -> irq 5
IOAPIC #0 intpin 17 -> irq 10
IOAPIC #0 intpin 18 -> irq 11
pci0:  on pcib0
agp0:  mem 0xd0000000-0xd3ffffff at device 0.0 on pci0
pcib1:  at device 1.0 on pci0
pci1:  on pcib1
isab0:  at device 7.0 on pci0
isa0:  on isab0
atapci0:  port 0xf000-0xf00f at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0:  at 7.2 irq 2
Timecounter "PIIX"  frequency 3579545 Hz
chip0:  port 0x5000-0x500f at device 7.3 on pci0
pci0:  at 8.0 irq 5
rl0:  port 0xd400-0xd4ff mem 0xd9000000-0xd90000ff irq 10 at device 9.0 on pci0
rl0: Ethernet address: 00:10:b5:40:14:46
miibus0:  on rl0
rlphy0:  on miibus0
rlphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
rl1:  port 0xd800-0xd8ff mem 0xd9001000-0xd90010ff irq 11 at device 10.0 on pci0
rl1: Ethernet address: 00:10:b5:90:66:b8
miibus1:  on rl1
rlphy1:  on miibus1
rlphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
rl2:  port 0xdc00-0xdcff mem 0xd9002000-0xd90020ff irq 2 at device 11.0 on pci0
rl2: Ethernet address: 00:00:b4:c3:0c:0a
miibus2:  on rl2
rlphy2:  on miibus2
rlphy2:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
my0:  port 0xe000-0xe0ff mem 0xd9003000-0xd90033ff irq 2 at device 12.0 on pci0
my0: Ethernet address: 00:02:44:38:35:86
my0: autoneg complete, my0: link status good. (full-duplex, 100Mbps)
orm0:  at iomem 0xc0000-0xc7fff,0xc8000-0xcbfff on isa0
pmtimer0 on isa0
fdc0:  at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
atkbdc0:  at port 0x60,0x64 on isa0
atkbd0:  flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
vga0:  at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0:  on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: cannot reserve I/O port range
DUMMYNET initialized (011031)
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default
IPsec: Initialized Security Association Processing.
SMP: AP CPU #1 Launched!
ad0: 8693MB  [17662/16/63] at ata0-master UDMA33
Mounting root from ufs:/dev/ad0s1a