Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.8-RELEASE #0: Wed Jun 11 01:11:43 MSD 2003 root@dragonbsd.da.ru:/usr/src/sys/compile/SERVER Timecounter "i8254" frequency 1193182 Hz CPU: Pentium II/Pentium II Xeon/Celeron (233.87-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x634 Stepping = 4 Features=0x80fbff real memory = 268435456 (262144K bytes) config> q avail memory = 257859584 (251816K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 FreeBSD/SMP: Multiprocessor motherboard cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc034c000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc034c09c. VESA: v2.0, 2048k memory, flags:0x1, mode table:0xc00c0e38 (c0000e38) VESA: S3 Incorporated Trio3D. netsmb_dev: loaded Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 8 entries at 0xc00f8100 apm0: on motherboard apm0: found APM BIOS v1.2, connected at v1.2 npx0: on motherboard npx0: INT 16 interface pcib0: on motherboard IOAPIC #0 intpin 19 -> irq 2 IOAPIC #0 intpin 17 -> irq 16 IOAPIC #0 intpin 18 -> irq 17 pci0: on pcib0 pcib1: at device 1.0 on pci0 pci1: on pcib1 pci1: at 0.0 isab0: at device 7.0 on pci0 isa0: on isab0 atapci0: port 0xffa0-0xffaf at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 uhci0: port 0xdc00-0xdc1f irq 2 at device 7.2 on pci0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered intpm0: port 0x440-0x44f irq 9 at device 7.3 on pci0 intpm0: I/O mapped 440 intpm0: intr IRQ 9 enabled revision 0 smbus0: on intsmb0 smb0: on smbus0 intpm0: PM I/O mapped 400 rl0: port 0xd800-0xd8ff mem 0xefffff00-0xefffffff irq 16 at device 14.0 on pci0 rl0: Ethernet address: 00:02:44:5c:b4:bf miibus0: on rl0 rlphy0: on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto bktr0: mem 0xe7dfe000-0xe7dfefff irq 17 at device 15.0 on pci0 iicbb0: on bti2c0 iicbus0: on iicbb0 master-only iicbus1: on iicbb0 master-only smbus1: on bti2c0 smb1: on smbus1 bktr0: Card has no configuration EEPROM. Cannot determine card make. bktr0: Intel Smart Video III/VideoLogic Captivator PCI, tuner. pci0: (vendor=0x109e, dev=0x0878) at 15.1 irq 17 rl1: port 0xd400-0xd4ff mem 0xeffffe00-0xeffffeff irq 2 at device 16.0 on pci0 rl1: Ethernet address: 00:02:44:5c:b4:bc miibus1: on rl1 rlphy1: on miibus1 rlphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto orm0: