Copyright (c) 1992-2005 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.4-RELEASE #1: Fri Dec 31 04:42:46 UTC 1999 root@pcserver.local:/usr/src/sys/i386/compile/GENERIC686SMP Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Pentium II/Pentium II Xeon/Celeron (299.17-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x652 Stepping = 2 Features=0x183fbff real memory = 134217728 (128 MB) avail memory = 121696256 (116 MB) MPTable: FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs cpu0 (BSP): APIC ID: 1 cpu1 (AP): APIC ID: 0 ioapic0: Assuming intbase of 0 ioapic0 irqs 0-23 on motherboard npx0: on motherboard npx0: INT 16 interface cpu0 on motherboard cpu1 on motherboard pcib0: pcibus 0 on motherboard pci0: on pcib0 pci0: at device 7.0 (no driver attached) pcib1: at device 11.0 on pci0 pci1: on pcib1 ips0: port 0x5100-0x51ff mem 0x50000000-0x50001fff irq 18 at device 3.0 on pci1 ahc0: port 0x5000-0x50ff mem 0x50002000-0x50002fff irq 19 at device 4.0 on pci1 aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs pcn0: port 0x5200-0x521f mem 0x50003000-0x5000301f irq 16 at device 5.0 on pci1 miibus0: on pcn0 nsphy0: on miibus0 nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pcn0: Ethernet address: 00:60:94:57:13:77 pcn0: if_start running deferred for Giant sym0: <875> port 0x6000-0x60ff mem 0x50100000-0x50100fff,0x50101000-0x501010ff irq 16 at device 13.0 on pci0 sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. xl0: <3Com 3c905C-TX Fast Etherlink XL> port 0x6100-0x617f mem 0x50101100-0x5010117f irq 17 at device 15.0 on pci0 miibus1: on xl0 xlphy0: <3c905C 10/100 internal PHY> on miibus1 xlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto xl0: Ethernet address: 00:01:02:b7:27:7d isab0: at device 19.0 on pci0 isa0: on isab0 atapci0: port 0x61a0-0x61af,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 19.1 on pci0 ata0: channel #0 on atapci0 ata1: channel #1 on atapci0 uhci0: port 0x6180-0x619f irq 19 at device 19.2 on pci0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered orm0: at iomem 0xc8000-0xc87ff,0xc0000-0xc7fff on isa0 pmtimer0 on isa0 atkbdc0: at port 0x64,0x60 on isa0 atkbd0: irq 1 on atkbdc0 kbd0 at atkbd0 psm0: irq 12 on atkbdc0 psm0: model Generic PS/2 mouse, device ID 0 fdc0: at port 0x3f0-0x3f5 irq 6 drq 2 on isa0 fd0: <1440-KB 3.5" drive> on fdc0 drive 0 ppc0: at port 0x3bc-0x3c3 irq 7 on isa0 ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode ppbus0: on ppc0 plip0: on ppbus0 lpt0: on ppbus0 lpt0: Interrupt-driven port ppi0: on ppbus0 sc0: at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A vga0: at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 unknown: can't assign resources (port) unknown: can't assign resources (irq) unknown: can't assign resources (port) unknown: can't assign resources (port) unknown: can't assign resources (port) unknown: can't assign resources (port) Timecounters tick every 10.000 msec Waiting 15 seconds for SCSI devices to settle (noperiph:sym0:0:-1:-1): SCSI BUS reset delivered. ips0: reinitializing adapter, this could take several minutes. ips0: ERROR: ffdc reset command failed! ips0: adapter type: ServeRAID onboard (copperhead) ips0: logical drives: 1 ips0: Logical Drive 0: RAID1 sectors: 8812544, state OK ipsd0: on ips0 ipsd0: Logical Drive (4303MB) sa0 at sym0 bus 0 target 2 lun 0 sa0: Removable Sequential Access SCSI-2 device sa0: 5.000MB/s transfers (5.000MHz, offset 8) SMP: AP CPU #1 Launched! cd0 at sym0 bus 0 target 6 lun 0 cd0: Removable CD-ROM SCSI-2 device cd0: 10.000MB/s transfers (10.000MHz, offset 15) cd0: Attempt to query device size failed: NOT READY, Medium not present Mounting root from ufs:/dev/ipsd0s1a =============================================================================== MPTable, version 2.0.15 ------------------------------------------------------------------------------- MP Floating Pointer Structure: location: EBDA physical address: 0x0009da10 signature: '_MP_' length: 16 bytes version: 1.1 checksum: 0xa0 mode: Virtual Wire ------------------------------------------------------------------------------- MP Config Table Header: physical address: 0x0009da20 signature: 'PCMP' base table length: 300 version: 1.4 checksum: 0xba OEM ID: 'IBM ' Product ID: '8640 PCI ' OEM table pointer: 0x00000000 OEM table size: 0 entry count: 29 local APIC address: 0xfee00000 extended table length: 0 extended table checksum: 0 ------------------------------------------------------------------------------- MP Config Base Table Entries: -- Processors: APIC ID Version State Family Model Step Flags 1 0x11 BSP, usable 6 5 2 0x183fbff 0 0x11 AP, usable 6 5 2 0x183fbff -- Bus: Bus ID Type 0 PCI 1 PCI 2 ISA -- I/O APICs: APIC ID Version State Address 2 0x11 usable 0xfec00000 -- I/O Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN# ExtINT active-hi edge 2 0 2 0 INT active-hi edge 2 1 2 1 INT active-hi edge 2 0 2 2 INT active-hi edge 2 3 2 3 INT active-hi edge 2 4 2 4 INT active-hi edge 2 5 2 5 INT active-hi edge 2 6 2 6 INT active-hi edge 2 7 2 7 INT active-hi edge 2 8 2 8 INT active-lo level 2 9 2 9 INT active-lo level 2 10 2 10 INT active-lo level 2 11 2 11 INT active-hi edge 2 12 2 12 INT active-lo edge 2 13 2 13 INT active-lo level 2 14 2 14 INT active-lo level 2 15 2 15 INT active-lo level 0 13:A 2 16 INT active-lo level 0 15:A 2 17 INT active-lo level 0 19:D 2 19 INT active-lo level 1 3:A 2 18 INT active-lo level 1 4:A 2 19 INT active-lo level 1 5:A 2 16 -- Local Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN# NMI active-hi edge 0 0:A 255 1 ===============================================================================