Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.0-CURRENT #3: Sat Mar 29 11:23:20 CET 2003 root@fatcat:/usr/obj/usr/src/sys/FATCAT Preloaded elf kernel "/boot/kernel/kernel" at 0xc03d8000. Timecounter "i8254" frequency 1193182 Hz CPU: Intel(R) Xeon(TM) CPU 1.80GHz (1796.52-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0xf27 Stepping = 7 Features=0xbfebfbff Hyperthreading: 2 logical CPUs real memory = 1610612736 (1536 MB) avail memory = 1562497024 (1490 MB) Programming 16 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 Programming 16 pins in IOAPIC #1 FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs cpu0 (BSP): apic id: 6, version: 0x00050014, at 0xfee00000 cpu1 (AP): apic id: 7, version: 0x00050014, at 0xfee00000 cpu2 (AP): apic id: 0, version: 0x00050014, at 0xfee00000 cpu3 (AP): apic id: 1, version: 0x00050014, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x000f0011, at 0xfec00000 io1 (APIC): apic id: 3, version: 0x000f0011, at 0xfec10000 Allocating major#253 to "net" Allocating major#252 to "g_ctl" Allocating major#251 to "pci" Pentium Pro MTRR support enabled npx0: on motherboard npx0: INT 16 interface pcibios: BIOS version 2.10 Using $PIR table, 15 entries at 0xc00fded0 pcib0: at pcibus 0 on motherboard pci0: on pcib0 IOAPIC #1 intpin 14 -> irq 2 pci0: at device 4.0 (no driver attached) fxp0: port 0x1400-0x143f mem 0xf8000000-0xf80fffff,0xf8101000-0xf8101fff irq 2 at device 5.0 on pci0 fxp0: Ethernet address 00:30:05:2e:3f:8e miibus0: on fxp0 inphy0: on miibus0 inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto isab0: at device 15.0 on pci0 isa0: on isab0 atapci0: port 0x1800-0x180f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 15.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: simplex device, DMA on primary only ata1: at 0x170 irq 15 on atapci0 pcib3: at pcibus 3 on motherboard pci3: on pcib3 pcib1: at pcibus 1 on motherboard pci1: on pcib1 IOAPIC #1 intpin 10 -> irq 5 em0: port 0x1c00-0x1c3f mem 0xfa000000-0xfa01ffff irq 5 at device 9.0 on pci1 em0: Speed:N/A Duplex:N/A pcib2: at pcibus 2 on motherboard pci2: on pcib2 IOAPIC #1 intpin 6 -> irq 9 IOAPIC #1 intpin 13 -> irq 10 pcib4: at device 9.0 on pci2 asr0: mem 0xfc000000-0xfdffffff irq 9 at device 9.1 on pci2 asr0: major=154 asr0: ADAPTEC 2100S FW Rev. FS02, 1 channel, 256 CCBs, Protocol I2O sym0: <1010-66> port 0x2000-0x20ff mem 0xfa400000-0xfa401fff,0xfa402000-0xfa4023ff irq 10 at device 10.0 on pci2 sym0: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. sym0: handling phase mismatch from SCRIPTS. orm0: